For the excavator, the existence of the bucket is very important, because the excavator bucket plays a key role in hoisting, loading, leveling, pushing and pulling, etc., but after a long period of use , The excavator bucket will gradually produce wear and tear, so it is still necessary to do a good job in the maintenance of the excavator bucket, in order to avoid some losses during the use of the bucket.

The excavator bucket is divided into several parts to form a total product. Bucket back, bucket edge, bottom plate, blade and bucket teeth. The operator knows that the degree of wear of the bucket by the stone is severe. If some vehicles use brute force to shovel the stone, the excavator bucket will often leave serious injuries.

In the working environment of the gravel yard, the ore received is not uniform in size. There are 3 places where powder and other crushed stones are mixed in Duitou. In addition, the mine carts are all unloaded directly from the platform above, and the piles of rocks have been compacted by the mine carts over the years, causing some corners to be tight. Of course, experienced masters can see the angle of the piles of stones on both sides and can easily start. But in the middle is always to shovel. The excavator bucket is very difficult for the shovel of this kind of pile head. The tight pile head must be pried from time to time to loosen a little. At this time, the bucket teeth, blades and bucket side plates are all large areas of force. , The degree of loss can naturally be imagined. After a long period of working friction, the teeth and side plates have reached some replacement period.

The side plate of the excavator bucket is also the main stress area. Weld a few steel plates for the last eight rounds. Over time, you will find that the loss of the side board is almost minimal. However, I personally support another side plate reinforcement method, which is to measure the size of the side plate close to the area, and then go to the steel plant to buy an iron plate with a thickness of more than 1 minute to reinforce it, so that it can be regarded as worry-free.

Reinforcement of the bottom plate: The new excavator buckets now use two U-shaped iron bottoms. The old buckets are very wear-resistant by adding one to the original bottom plate size. If you see that the two U-shaped iron plates of the bottom plate are worn to a large extent, measure the size of the U-shaped iron plate, and then reinforce it!